SUMMARY:

Under direction of the electronics line supervisor, responsible for assembly, calibration, and final test of instruments, modules, and optical heads.

ESSENTIAL DUTIES AND RESPONSIBILITIES:

Electronic Line Responsibilities.

• Mechanical assembly, wiring, solder connections, cable fabrication, and power on test of instruments and modules in accordance with written procedures.
• Trouble shooting down to sub-system level identifying PCBA, power supplies, optical heads, cables, wiring, switches, displays, and other components for replacement.
• Fill out travelers, test data sheets, and tracking documentation.
• Rework PCB's including replacement of components, connectors, heat sinks, power supplies, and other components as needed.
• Program testing using temperature chambers, shaker tables, and other environmental test equipment as required
• Under the direction of engineers, perform complex testing tasks including measurement using oscilloscopes, digital volt meters, signal generators, and logic analyzers.
• Fill out trouble shooting logs.
• Maintain assembly station equipment, including soldering irons, rework equipment, and test cables.
• Organize and keep tidy assembly stations and test stations.
• Suggest corrections to assembly procedures, test procedures, schematics, and other manufacturing and engineering documentation.
• Mechanical fabrication of equipment brackets, aluminum boxes, and light machining work as needed to support electronic products.
• Perform incoming test inspections on PCBA and other electronic components using written procedures.
• Integrate fiber optical components and optical sub-systems via optical connector or single mode fusion splicing.
• Load firmware onto embedded processors, DSP's and FPGA's.

Other Responsibilities.

• Testing support for the optical line, PCS line, and mechanical line.
• Support R&D with special project assembly and test.
• Promotes company's mission and values.
• Supports Quality Management System
• Supports good health and safety practices
• Supports other departments as required
• Other duties as assigned by Management

EDUCATION REQUIRED:

• Associate degree highly preferred (or equivalent experience)
• Certification in Electronics is highly desirable

EXPERIENCE REQUIRED:

• 3-5 years related job experience

SKILLS REQUIRED:

• Experience working with Microsoft Word and Excel.
• Able to run test software, LabVIEW experience desirable.
• Very experienced in cable fabrication, hand soldering, rework, mechanical assembly, and operation of basic electronic test equipment.
• Experience with optical fiber connectors and fusion splicing desirable.
• Able to read schematics and system diagrams.
• Should be able to do fabrication of electronic systems from limit documentation including marked up schematics and basic wiring diagrams.
• Understand how to install firmware on embedded systems.
• Must be a good team member with a positive attitude and cheerful disposition.
• Should be comfortable working under pressure to tight deadlines on a daily basis.

WORK ENVIRONMENT:

Approximately 90% of the work is performed on the manufacturing production floor. The remainder is spent between the R&D lab, inventory stock room, and IQC area.

Luna is an Equal Employment Opportunity Employer – Minorities/Females/Veterans/Individuals with Disabilities/Sexual Orientation/Gender Identity