This position reports directly to the Production Supervisor and is responsible for the general and specific job duties of IAC as described below:

General Job Duties:

• Exhibit teamwork skills and actively participate in team activities in a positive working environment.
• Demonstrate problem solving skills in a work environment that is striving for continuous improvement.
• Adhere to all safety and health objectives, policies and procedures to provide for a safe and healthful workplace. Work in a safe manner at all times and report any unsafe conditions to your supervisor in order that the situation can be corrected. Report all accidents and near misses in a timely manner when they occur.
• Maintain proper ergonomics at all times when performing assigned tasks.
• Meet and maintain all company and customer quality standards.
• Participate and support all lean, continuous improvement programs, initiatives and activities.
• Meet or exceed daily production goals and departmental objectives as directed.
• Clean all assigned work areas after completion of the required work, return all tools to proper storage area at the end of the shift and report any malfunctioning equipment.
• Direct all non-conforming parts to the appropriate reprocess area.
• Maintain proper radio etiquette when using company radios, PA system and/or phone, business use only.
• Work overtime as needed in accordance with Company Policy.
• Perform all assigned tasks per the TPM, SOP (standard operating procedures), manufacturing alerts, safety alerts and quality alerts.
• Perform other duties as assigned.

Specific Job Duties:

• Inspect parts for defects
• Place labels in appropriate spots
• Verify that spring nuts are installed correctly
• Scan parts to make shipping label
• Write clock number on parts and labels
• Load substrates on router fixtures
• Remove parts from router
• Trim parts and discard excess trim
• Clean router fixtures with an air gun
• Fill HVLP spray gun with mold release
• Complete First Piece checks
• Blow out debris from nest before loading skin with an air hose
• Sift powder to protect the mold
• Wax molds with a brush before every shift

• Insert/attach components, ie. Air bag chute, clips.

• Use air gun to remove excess water and dirt from various nests.

• Prep substrates for FIP molding.
• Verify sonic score.

• Remove excess foam, skin, and tape from parts.

• Clean parts and racks as needed

Requirements

• High School diploma or equivalent
• Ability to read, write and speak English effectively along with basic mathematical skills
• Capable of performing work while standing for a minimum of eight (8) hours a day
• Capable of performing sustained motion for a minimum of eight (8) hours a day and capable of repetitive motion for up to four (4) hours a day
• Ability to lift up to 15 pounds on a frequent basis and up to 40 pounds on an occasional basis
• Perform work that is below the knees and above shoulders on an occasional basis
• Previous manufacturing experience preferred

PPE Requirements

• This position requires the use of eye protection and hearing protection. When handling a cutting utensil a cut glove and cut sleeve must be worn per safety requirements. Other required PPE is task specific.